Skip to main content

Updating a Static Route

This page explains the procedure for updating a Static Route using the OCX Portal.

Preparation​

Please confirm the following before updating a Static Route:

  1. Your User Role is either admin or user.
  2. The target Internet Gateway resource is in either the available or attached status.

Procedure for Updating a Static Route​

  1. Log in to the OCX Portal.

  2. Click [Internet Gateways] from the left navigation bar.

  3. From the Internet Gateways page, click the target Internet Gateway resource.

  4. A detail screen will appear at the bottom of the page. Switch to the [Static Routes] tab.

  5. Once the Static Route list is displayed, click the Edit icon in the Actions column on the right side of the corresponding Static Route.

  6. The screen will switch to the configuration change steps. The following items can be modified: After entering the changes, click [Edit].

    • Prefix
      • Enter the IP address of the network you wish to add in CIDR (IPv4/mask) format (e.g., 192.168.0.0/24).
      • Note: Please ensure the IP address is entered as a network address.
    • Next Hop
      • Enter the IP address of the network relay point (Next-Hop) for the destination (e.g., 192.168.0.1).
      • Note: You cannot set addresses as the next hop if they are network addresses, broadcast addresses, or addresses outside the range of your own Internet Gateway.

  7. A confirmation pop-up will appear. If there are no issues with the content, click [Edit].

  8. The Static Routes list will be displayed at the bottom of the screen. Confirm that the changes have been reflected.

This completes the process for updating the Static Route.