Skip to main content

Updating Static Routes

This page explains the procedure for updating a Static Route using the OCX Portal.

Preparation​

Please confirm the following before updating a Static Route:

  1. Your User Role is either admin or user.

Procedure for Updating a Static Route​

  1. Log in to the OCX Portal.

  2. Click [OCX-Router(v1)] from the left navigation bar.

  3. On the OCX-Router(v1) page, click the specific Interface within the relevant OCX-Router(v1) resource.

  4. The details panel will appear at the bottom. Switch to the [Static Routes] tab.

  5. Once the Static Route list is displayed, click the Edit icon in the Actions column on the right side of the target Static Route.

  6. The screen will switch to the settings modification step. The following items can be modified. After completing the input for the items you wish to change, click [Update].

    • Prefix
      • Enter the IP address of the network you wish to add in CIDR (IPv4/mask) format (e.g., 192.168.0.0/24).
      • Note: Ensure the IP address is entered as a network address.
    • Next-Hop
      • Enter the IP address of the relay point (Next-Hop) for the destination network (e.g., 192.168.0.254).
      • Note: You cannot set a network address, broadcast address, or an address that resides outside the range of your own Interface.

  7. A confirmation pop-up will appear. If the details are correct, click [Update].

  8. The Static Routes list will be displayed at the bottom of the screen. Confirm that your changes are reflected.

This completes the update of the Static Route.